Q-Logic FIRMWARE VERSION 7.4 Manuel d'utilisateur télécharger pdf (Page 43)

3 – Event Messages

Alarm Events

59060-05 A 3-29

(A1005.006D) (Unable to synchronize with NTP server)

Meaning: The switch was unable to synchronize its time clock with the

Network Time Protocol (NTP) server.

Action: Confirm that the NTP service and NTP client are enabled. Confirm

that the NTP server IP address is correct and that the server is

operating.

(A1005.006E) (A reset is required to activate this version of firmware)

Meaning: The installed firmware cannot be activated without disrupting I/O

traffic.

Action: Perform a hard reset.

(A1005.006F) (Hotreset Vversion -> Vversion is not supported)

Meaning: The installed firmware cannot be activated without disrupting I/O

traffic.

Action: Perform a hard reset.

(A1005.0070) (Hotreset to older firmware version not supported. A reset is required to

activate this version of firmware)

Meaning: The installed firmware cannot be activated without disrupting I/O

traffic.

Action: Perform a hard reset.

(A1005.0071) (Unable to obtain dynamic IP address, falling back to static IP address of

address on interface interface)

Meaning: The switch was unable to obtain its IP address from the Dynamic

Host Configuration Protocol (DHCP) server. The static IP address

will be used.

Action: Investigate the DHCP server.

(A1005.0072) (Unable to turn off lasers, please power off the switch)

Meaning: Conditions exist that could damage the switch and the switch was

unable to turn off the Fiber Channel port lasers.

Action: Power down the switch and contact your authorized maintenance

provider.

(A1005.0073)(Blade fault fault reported)

Meaning: The named blade fault has occurred.

Action: Contact your authorized maintenance provider.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 83 84

Pas de commentaire

Q-Logic FIRMWARE VERSION 7.4 Manuel d'utilisateur Page 43