Q-Logic 42051 Manuel d'utilisateur Page 52

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 196
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 51
4 – Installation
Installing a Switch
4-4 59021-06 A
D
When mounting the switch in a rack, ensure that the 19-inch rack meets the
following standard specifications:
ANSI/EIA RS-230 Standard, entitled Cabinets, Racks, Panels, and
Associated Equipment
MIL-STD- 189, entitled Racks, Electrical Equipment, 19-Inch and Associated
Panels
The brackets shown in Figure 4-2 are provided with the switch so that the switch
can be secured on a shelf. The brackets alone are not designed to support the
weight of the switch.
Figure 4-2. Installing Rack Mount Brackets
4.2.2
Install SFP Transceivers
The switch has been validated with transceivers that support a variety of
interconnection media. To install, insert the transceiver into the port and gently
press until it snaps in place. To remove a transceiver, gently press the transceiver
into the port to release the tension, then pull on the release tab or lever and
remove the transceiver. Different transceiver manufacturers have different release
mechanisms. Consult the documentation for your transceiver.
Note: The SFP transceiver will fit only one way. If the SFP does not install
under gentle pressure, flip it over and try again.
Vue de la page 51
1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 195 196

Commentaires sur ces manuels

Pas de commentaire