Q-Logic 64 Manuel d'utilisateur Page 107

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 244
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 106
6 – Removal/Replacement
Cross-Connect Blades
59043-03 A 6-13
D
6. Remove the switch cover. Use a medium crosshead screw driver to remove
the four screws on each side and the six screws on top as shown in
Figure 6-4. Lift and remove the switch cover and set it aside. Put on an ESD
wrist strap and connect it to ground.
Figure 6-4. Switch Cover Removal
7. Remove the CC blade. Loosen the six screws (1) that fasten the CC blade to
the chassis as shown in Figure 6-5, but do not remove them. The three
screws nearest the latches (2) need only be loosened a couple turns. The
three screws nearest the backplane (3) must be backed off about 3/8 of inch
to allow enough clearance to remove the blade.
Figure 6-5. CC Blade Removal
3
1
1
1
1
2
2
1
Vue de la page 106
1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 243 244

Commentaires sur ces manuels

Pas de commentaire